if your under miles its under warrenty
how to replace the license plate bulb on a 2004 Honda cr-v
how do you replace a honda crv licence plate bulb on a 2004
I have a 94 not sure if they are the same but behind the license plate was mine Good luck Answer Improvement (Sept 5. 2010) Remove 4 license plate screws and licence plate Remove 4 hex head screws that hold the license plate/backup light assembly Rotate the license plate/backup light assembly around 180 degrees so you can get to the light bulb holders Carefully turn bulb holders 1/4 and remove bulb holder Carefully remove old bulb and replace with new bulb (#194) Reverse these step to reassemble
Remove the screws from the lens covering the bulb, pull out the bulb and replace it.
This is an easy one, but.... I spent a good half an hour figuring it out. The license plate lamp requires no tools to replace. Above the license plate is a small bulb housing. At the back of the bulb housing is the bulb socket that locks into place. Simply turn the socket 90 degrees moving the socket clockwise as you're facing the rear of the car and wiggle it out. The bulb simply pulls out and the new one pushes in!
You need to unscrew the whole cover panel for license plate.
Ask your car dealer...
You need a torx screwdriver....
you buy a new one
Raise the trunk lid...you will see the lights on each side of the license plate...use Phillips screw driver to remove and replace bulb. Just did this takes about 2 minutes.
pop your hood and find the what "FUSE PANEL" find the fuse marked Parking lights and replace it. Its that simple. it might not be a fuse have you replaced the bulb or checked your contacts from your wiring?