Should be located in a removable housing at the engine end of the upper radiator hose
Drain about 1 gallon of coolant from the radiator
Remove this housing
Make note how thermostat is installed
Clean both surfaces
Install new thermostat and replace housing
Re-fill coolant slowly to prevent an air lock
Start engine and look for leaks
Run engine to normal operating temperature with heater on
Re-check coolant level
-----------------------------------------------------------
This is incorrect it is not there do not mess with that part unless you want to pay for more gaskets for no reason !
The chevy malibu 2.4l 4 cylinder is different it is located ant the end of the lower radiator hose, follow it down till you see bolts not a clamp it is attacked to a metal piece and goes up and is a lot harder to mess with i know this because i am doing this same exact thing myself.
What you need to do:
Get one the of more high dollar thermostat with fail safe stick this thermostat is the best of the best unlike other thermostats if it fails it locks open instead of closed saving your block from going out and bubbling out of over flow tank !
Call a mechanic
Give me a diagram of the location of the thermostat on a 2001 Chevy Malibu
Drain the radiator. The thermostat is in a housing connected to the water pump. Remove the housing to replace the thermostat and gasket.
the thermostat is in the coolant cap
How do you replace vent windowin a 2005 chevy malibu?
The 1981 Chevy Malibu 350 engine thermostat is located on the front of the engine. You can follow the water supply hose from the radiator to the thermostat.
Yes, it has one.
Remove the water supply hose from your 1988 Chevy Cavalier thermostat housing. Remove the thermostat housing bolts. Lift the old thermostat out and drop in the new thermostat.
Where is the thermostat located at on a 2004 Chevy Malibu 3.5 liter V6
The water pump on a 97 Chevy Malibu 4 cylinder is replaced by removing the engine accessories, drive belt, and radiator hoses. The pump can then be unbolted, removed, and a new pump installed.
The 2000-2005 Chevrolet Impala only came with a 3.4 and 3.8 V6 (6 cylinder) engines. Are you sure that you don't have a Malibu instead? at the emd of the upper rad hose you will find the thermostat housing. Take the 2 bolts out and remove it. When reinstalling it make sure the spring on the thermostat goes toward the engine.
HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU