answersLogoWhite

0


Best Answer

You have to remove the top and side covers on the steering wheel column, remove I think 4 screws-bolts, disconnect the wire connection, and remove the old switch.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace a multifunction switch on a 1993 Lincoln mark viii?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the multifunction switch on a 1997 intrepid?

Remove the tilt steering lever.Remove the steering column cover.Unplug the wire going to the switch.Now you can remove the bolts that hold the switch to the column.An instructional video of how to remove the multifunction switch on a 1993-1997 Dodge Intrepid has been included below.


Where is the multifunctional switch located in a 1993 Lincoln Marc viii?

the turn signal handle is made to the multifunction switch. It operates the turn signals, brake light, emergency lights, ect. drl


How do you install multifunction switch 1993 Lincoln town car?

That should be inside the cover of your steering column The turn signal lever and hazard flasher button stick outside of the steering column cover


Replace ignition switch for 1993 Buick century?

Replace ignition switch for 1993 buick century?


How Do You Replace A Headlight Switch In A 1993 Oldsmobile Cutlass Ciera?

how do you replace the headlight switch on a 1993 cutlas ceria*


How do you replace a 1993 Corvette headlight dimmer switch?

How do I change the dimmer switch on my 1993 corvette?


Is there a heater core reset switch on a 1993 Lincoln continental?

No.


How to replace a Power window switch on a 1993 Buick Skylark?

Do you mean the main switch by the driver or the switch on the door itself?


How do you replace the fuel pump on a 1993 Lincoln MK8?

You have to drop the fuel tank, replace the pump then re-install.


How do you replace a power window switch for a 1993 Chevrolet camaro?

pry out the control switch and disconnect the electrical connectors.install is reverse.


Lights only work when you hold the brights lever back anyone know whats the problem or how to fix of a 1993 dodge Dakota?

There are two circuits at the multifunction switch lever. One is for the flash to pass. The other is the normal high/low beam circuit. The two most likely problems are a lack of power from the headlight switch, or a broken wire at the multifunction switch connector. The second is prone to happening if you tilt the wheel frequently.


How do you take the head light dome light switch off on a 1993 Mercury Cougar?

You don't. The switch is all one , you will have to replace the entire switch.