0
Serpentine Belt
Under the hood should be a diagram of the belt, this is your best reference without the service manual. All you have to determine is which direction to rotate the belt tensioner, and then put the belt back on as shown in the diagram.
If it is not you can run down to your nearest auto parts store and they can print it out for you or just buy the Hayes or chilton manual on your car. It only cost a few bucks and it well helps you out later down the line if something else brakes.
Relieve Serpentine Belt Tension.
Before removing the belt, note its routing around all applicable pulleys for ease of installation.
1. Using a box end wrench on the tensioner pulley center bolt, rotate the tensioner assembly clockwise.
2. While holding the tensioner in this position, remove the alternator drive belt from one or two of the applicable pulleys.
Use a box end wrench to rotate the tensioner pulley assembly clockwise to relieve serpentine belt tension
1. Slowly release the tensioner, and remove the box end wrench from the center bolt.
2. Remove the alternator drive belt from the remaining applicable pulleys.
To install:
When installing the drive belt on the pulleys, ensure that it is properly seated in all of the pulley grooves.
1. Using the box end wrench, rotate the tensioner clockwise again, then position the drive belt on all of the pulleys.
2. Slowly release the tensioner until it eliminates all drive belt slack.
3. Inspect the tensioner indicator to be sure that the belt is properly tensioned. If the belt tension is incorrect, the belt should be replaced with a new one, or, if installing a new belt, the belt may not be the correct belt for your vehicle.
4. Then start the engine. Ensure that the drive belt works properly.
- Stop the engine, then double-check to ensure that the belt is properly seated on all applicable pulleys.
Add your answer:
Earn +20 pts
How do you replace an idler pulley on a 1997 Ford F150 5.4ltr?
Remove serpentine belt. Remove pulley. Install new pulley. Install serpentine belt.
Where is the drive belt adjusting bolt on a F150?
no adjusting bolt u have a serpentine belt.that has a tension pulley that automatically adjusts if belt is loose, u need to replace belt
How do you replace the alternator on a 92 F150?
Disconnect both battery terminals. loosen the alt. bolts, remove the drive belt. then remove the bolts holding thr alt.
How do you replace an oil pump on a 1997 Ford F150?
half inch..
How do you replace the odometer gear on a 1997 F150?
no, I want to know, where do i start?
How do you tell if timing belt is bad on 1997 ford f150 4.6l?
It uses a timing chain
How do you replace freeze plugs between the motor and transmission on a 1997 Ford Taurus?
how do you replace the freeze plugs between the transmision and motor on a 1997 f150 5.4
How do you replace serpentine belt on 2004 f150?
the easyiest way to change it would be to buy the belt then take it to the ford dealer ship and have them put it on
Can you replace your serpentine belt on your 97 Ford F150 v-8 4x with ac to a standard serpentine belt for a Ford F150 without ac as you feel the ac compressor is shot?
yes,a good parts man will give you a belt to bypass your ac.
When do you have to change the timing belt on a Ford F-150?
Need to know what engine and year. Most engines before 1997 in a F150 do not have a timing belt, they have a chain.
Should you replace front coil springs on 1997 Ford F150 when changing the shocks?
No , unless the spring is damaged
How much should it cost to replace a drive shaft in a F150 4.2 engine?
Get it checked by a certified tech with experience first.
