The starter kill wire is blue and red and is located in the ignition switch harness on the 2001 Volkswagen Jetta. The wire can be disconnected at the harness or at the starter itself.Ê
Disconnect your battery, then remove the two nuts from the starter wire harness. Pull the wire and cable of the studs. Remove starter bolts and slide starter out of bellhosing.
The wire from the battery to the starter does not include a fuse.
try this.this is how it works on my 98 jgc. hope it helps Disconnect your battery, then remove the two nuts from the starter wire harness. Pull the wire and cable of the studs. Remove starter bolts and slide starter out of bellhosing.
You have to remove the starter and run a new wire
Check that the wire on the rear defroster is connected to the defroster. If broken off repair it.
Any time you disengage the battery cables, it is recommended that you disconnect the negative (-) battery cable first. This will prevent your accidentally grounding the positive (+) terminal to the body of the vehicle when disconnecting it, thereby preventing damage to the above mentioned components. Follow the big / fat wire (red) positive (+) wire from the battery to the starter. The big / fat wire (red) positive (+) wire will go from the battery to the starter. The starter is located between the motor and transmission. The starter turns the fight wheel to start the engine.
Lower front of the engine, accessed from below. Follow a rather large gauge wire leading down to the starter. Disconnect the negative wire from the battery before removing the starter. Disconnect connected wires, remove 2 mounting bolts.
You have a ground wire that isn't grounded causing a shortage therefore blowing the fuse....I would start with the ground wire that is connected directly to the starter itself
To replace the starter on the 2001 Lincoln Town car, first remove the battery cables from the battery. Then, remove the three wires from the starter. Then, remove the bolts holding the starter in place. The starter will then be easy to lift out of the vehicle. Replace the starter by first bolting the new starter in place and then adding the three wires.
how do you connect the wire from the alternater to the starter?
The ignition wire in a Nissan 350z is black and red. The starter wire is white/red and the second starter wire is white/green.