No.
No.
I did not get a answer
To remove the wiper arm, first remove the wiper blade. After the blade is removed, lift the arm just slightly to clear the tab protruding from the side of the arm. Pull the tab out after it ckears the arm and then pull the arm off the hub.
The EGR Valve is located on the intake manifold.
Find the leak and repair it with a compression or push-in fitting.
i dont care and dont know
I have a 1983 bronco full size and I had to replace my wiper motor. I had to remove the wiper blades and arms then I had to remove the cowl. once you remove the cowl it is pretty much straight forward from there it took me by myself about 3 hours to do this job. oh yah make sure you time the wiper arms before turning them on to try them. Hope this helps. Have a nice day
Sorry I don't have any specifics for you, but look for the Ford Light Truck Shop Manual for 1986 (eBay has 'em for $30).
yes, any small block dodge engine ( 273, 318, 340, 360) will fit in there. no mods required.
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
Yes you can remove it and still drive the truck......