All the seat...you get two parts; the back seat and the bottom where you sit...simple get in the car in the back on your knee on the floor face to the seat in the middle and with your two arms push on vertical parts of bottom seat each side and move it...because to remove you get two clamps to the floor you need to unknot....and lift it up pay attention to seatbelts if remove completely...not sure but some models get plastic on top remove before...after if you need the back seat, check where the seat belt attachment are(2) and with a big Torx remove the bolts and lif it up, do not forget you get two clamps on top tow!
To remove a 1993 Nissan maxima rear speakers you will have to remove the seat back, you will need a wrench to remove both of the bolts on each side. The seat will move once done, and then pop the parcel shelf trim. The speakers should come out.
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
Push down and back toward rear of car and lift out Hope this helps
Remove the two Allen bolts at the rear end of the seat with a hex wrench, then slide it back.
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm
at the bottom of the back of that seat their should be latches you push down to release!
The rear seat isn't designed to be removed. If you have a center bench seat you can remove that by unclipping it, then slide the rear seat forward.
The rear seat is not intended to be removed. You can remove the center seat and slide the rear on forward into it's place.
How do you remove the rear seat on a 2002 diamante
Remove rear seat and panel underneath seat. How do I remove rear seat?!?!
Try puting rearward pressure on the bottom of the seat bench (take a lot of force) tio release locking clips Lift up and remove bench There should be bolts or clips securing the back of the seat exposed Remove or release these and lift straight up on the rear of seat to release upper clips to remove rear of seat
remove the 2 bolts on the floor in front of the seat, and the 3 bolts on the floor at the rear of the seat.