I just removed the door cover today. I have a lock issue that I needed to remedy. Having an older truck, I have done this before. Remove all the screws (some star heads, some phillips); about 5 total. All screws are visible. Find two down at the bottom of the door, one in the handle and and so on. Pry slowly with a putty knife to (pop) the plastic tabs that hold the plastic to the metal. KEY: START FROM THE BOTTOM OF THE DOOR, this makes it easy to pry up. Lift the door panel up. 5 minutes time the door cover will be off. Be ver carful but forceful to pry the plastic.
remove all visible screws, and pry gently....there are clips that hold it to the door...also
Everyone should have a manual for their vehicle, and a professional shop manual should be available at your local library, just make copies of the right pages, as they are usually REFERENCE only...read up and good luck :)
Remove fuel tank--access at top of tank Remove fuel tank--access at top of tank
They are under the coils. You have to remove the coils to access.
The interior door panel, on a 2006 GMC Sierra pickup truck, can be removed by removing the retaining clips. The door handle should also be removed.
Remove bed to have access to tank. Easiest way to get to pump
remove the top dash pad.
I believe the handle is one whole assy handle holder and lever. remove door panel and assy should rivet/bolt to door
remove the stock tail light assembly. the bolts will be either in the tailgate area or you will have to remove the interior panel to access them.
remove the trim from the interior of the lift gate. There is access to the connecting rods that will release the catch from the Nader bolts.
Unscrew the grey pannel off of the talilight assembly to gain access to the light bulbs, then the bulbs remove from the pannel by simply pulling them out.
The expansion valve is located in front of the evaporator core. You must remove the housing to access it.
its easy you have to remove the interior light its between passenger and driver side under there u can see screw unscrew it whole aerial will come out .............. remove the interior light by pressing in side out with the screw driver from middle part of the plastic then access to the aerial ......
Remove Distributor,remove drive gear,remove shaft,remove pickup coil.