Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding * Disable the airbag system * Remove the tilt lever if equipped * Remove the upper and lower steering column covers Ignition Switch * Remove the ignition switch retaining screws * Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors Key Lock Cylinder * Turn the key to the run postion * Depress the lock button and remove the key lock cylinder
Remove the ignition switch retaining ring. Pull the ignition switch out. Remove the wiring harness from the back of the ignition switch. Reverse the process to install the new ignition switch.
You can remove the 2000 Chevrolet Astro Van the ignition switch cylinder by removing the retaining ring. The retaining ring will need to be turned to the left. The ignition switch cylinder will slide out.
You will need to remove the retaining ring at the top of your 1978 Chevrolet Blazer ignition switch. Slide the ignition barrel out and remove the wiring harness. Reverse the process to install the new ignition switch.
If you need to remove your ignition switch, you should consult your owners manual. Check for a guide on how to remove and replace and follow the instructions.
First you will have to remove the who steering wheel surrounds. Once this is removed, you will see the screws that are holding the ignition switch in place; remove those screws and then unhook all the wires.
how DO YOU REMOVE AN IGNITION CYLINDER FROM A MALIBU CHEVROLET 2000
How do you replace the ignition switch on a 2000 ford expedition?
Can anyone please tell me where the ignition switch is located on a 2000 oldsmobile silhouette?
A retaining clip holds the ignition switch in place on the back of the ignition cylinder on your 2000 Dodge Ram.
A 2000 Toyota Camry has an ignition switch fuse location in the main fuse panel. It helps protect the switch and the rest of the ignition system from surges.
No
remove instrument cluster, remove 2 screws holding switch in, push switch about 1 inch straight back to clear mounting bracket. pull straight out.