Really easy. Slowly pull off the front grill piece by pulling it out from top near the headlight and move around slowly. Take care with the cross bar ends as they are more delicate. There are two tabs on the light assembly. One on the top inside edge and one one the outside edge. Use a flat head screwdriver to slide that tab up and the one on the side outwards. The headlight assembly will now drop forward. www.trailvoy.com All the answers for your Trailblazer from true enthusiasts!
It pulls off. Sometimes easier to remove the headlight assembly to change the bulb. We have instructions at our forum. www.trailvoy.com Trailblazer enthusiasts!
Open the hood, stand in front of the effected headlight, notice the two tabs sticking up behind the radiator support in back of the headlight assembly. These tabs are locks that hold the headlight assembly in place. Lift the tabs up and remove them. Now you can wiggle the headlight assembly out the front and remove the bulb. Reverse for assembly.
How to remove headlight assembly on 2003 Lexus GX470
Remove the wiring harness from the back of the headlight. Remove the headlight assembly bolts. The headlight assembly will come out.
How do you remove the headlight assembly on a 2001 camaro?"
Begin by removing the wiring harness from the back of your headlight. Remove the headlight assembly retaining bolts. The headlight assembly will come out.
Remove the grill. It is held on by push pins so must be done carefully. The headlight is held in by two slide daggers. One is near the midline on the top portion of the headlight assembly. The other is down the side on the outside edge of the assembly. A stubby flat blade screwdriver works well to pop them out. They will not fall out as they have keepers to hold them when they are out all the way. All the answers are at www.trailvoy.com
Open the hood to the engine compartment. Remove the headlight wiring harness. Remove the headlight assembly bolts. There are four headlight assembly bolts. The headlight assembly will come out.
The bulb can be removed from the rear of the headlight assembly. Remove the boot first then twist the bulb to unlock it. If you cannot access the bulb you can remove the headlight assembly from the truck by pulling up the tabs on the two clips that hold it in place. One on the top corner near the midline of the truck and one on the side of the assembly. You may have to pop the grill out to allow easy access. www.trailvoy.com all the answers for your Trailblazer from enthusiasts.
If you can't reach inside and remove the rubber boot covering the back of the headlight assembly then do the following. Pull off the grill being careful not to break the clips or the plastic. Use a screwdriver to slide the dagger clips out that hold in the headlight assembly. You can see the tabs on the top inside and on the outside sides of the headlight assembly The headlight assembly will fall forward but you might have to remove the side marker light as the wires are very short. Now you should have easy access to the boots covering the bulbs. All bulbs remove with a twist and have tabs on them. www.trailvoy.com Trailblazer enthusiasts forum!
Remove the wiring harness from your 2000 Kia headlight. Remove the headlight assembly retaining bolts. Reverse the process to install your new headlight assembly.
how do you remove the headlight assembly on a 2001 ford f-250