How do you remove the governor form a Ford Probe?

Answer 1

It does not have a governor. Speed is computer controlled. you can, however, reprogram your computer to allow for a higher max speed. However, its a Ford Probe, not a true racing car. Buy a Mustang GT or a Trans-Am, or a Camaro. Or go foreign and get a Prelude or something. All 1989-1992 2.2L 4-cylinder engines non-turbo first generation Probes have a speedlimiter at 113mph. When the speed reaches 113mph, the ECU will shut off the fuel pump, forcing the vehicle to slow down. When the speed drops to 70mph, the ECU will reengage the fuel pump and engine control will return to normal. The circuit that controls the speed limiter is externally located from the ECU, allowing the possibility of altering the function. This will only work on 4-cylinder non-turbo models

Procedure speed limiter control

Gain access to either the instrument panel wiring harness under the dash board at the rear of instrument cluster, or the Electrical Control Assembly. There is a Yellow/White wire that runs between the instrument cluster and the ECU. Cut this wire and secure the ends.

Reassemble interior. Tools Required: Wire cutter.... REMEMBER The 113mph limiter is there for a reason. It is extremely dangerous to drive at high speeds. Do not attempt to test the function of the limiter on public roads where you can kill yourself or others. Many tires are not designed to handle speeds this high and can explode under the extreme temperatures. Remember, I am not condoning high speed or wreckless driving. And for the answer before mine, just for the record, the Ford probe was originally designed to replace the mustang. Also the probe GT may not have the 5.0, but can definitely keep up. I am a proud owner and wouldn't trade it for anything.