If your window is manual, remove the crank handle. If electric, carefully remove the switch panel and disconnect the electrical connector(s). Remove the interior trim panel, and then carefully remove the plastic insulation sheet from the door.
Look through the holes in the door sheet metal. At the bottom of the window glass, you should see the metal support for the glass. There will be two large hex-head bolts threaded into either yellow or orange plastic that hold the glass to its support brackett. Using the normal window controls, move the window up or down until the bolts line up with appropriate access holes in the sheet metal, and then unscrew them with a 5/8" socket and extension (you shouldn't have to use a ratchet, as the bolts aren't that tight.) When the bolts are removed, remove the plastic inserts that go through the matching holes in the glass. I recommend using a long pair of hemostats for this. Also, you may have to work your hand around behind the glass to push the inserts out. After they are removed, you should be able to lift the glass out of the door.
Installation is the reverse.
How to Remove or Install Car Window Crank Handles check related link below
Don't do that!It's a major mistake to do that!The airbag is a safety device. It is illegal to disable an air bag without written permission from the NHTSA
To replace a windshield wiper motor for a 1998 F150, first remove the bottom trim on the window. Then remove both wiper blade assemblies and all screws on the metal cowling. Remove the retaining clip from the wiper motor linkage and pull the controls rods off.
The arm rest can be removed from the seat on a 1998 F150 by locating the bolts holding it on. Remove the bolts with the proper tool and life the armrest from the seat carefully.
insisde tuck three nuts and wiring harness.
I am having trouble getting glove box out of 98 F150. I need a more detailed explanation of which screws need to be removed and their location.
The temperature gauge sensor on the 2002 F150 is located on the driver's side of the vehicle and under the intake. This is almost impossible to remove without removing the intake itself.
How do I replace the block heater in my 1998 F150 4.6L?
Your 1998 F150 has 3 relays for your power door locks : an all unlock relay / a driver unlock relay / and an ALL LOCK RELAY I'm guessing that the ALL LOCK RELAY has failed I'm sorry but I haven't found the location of the power lock/unlock relays on your F150 yet ( does anyone know the location of the power door lock / unlock relays on a 1998 F150 ? )
No, 97-03 F150's have a 5x135 lug pattern.
you should be able to get at heater core just by removing glove box.no need to remove all the dash Is there any instructions on how to do this?
window regulator cable is broken need new regulator