0
Chock the wheels to be sure vehicle will not roll. Mark the differential and drive shaft before removing drive shaft. Remove 4 bolts from differential-end of drive shaft. Place a pan under the transmission-end of drive shaft and have clean rags handy. Push the drive shaft slightly toward the front of the vehicle while pulling downward on the drive shaft and lower it to the ground. Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. Place the drive shaft on the ground and put rags in the transmission to prevent oil leakage and keep dust/dirt out. Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you remove a drive shaft in 1999 Ford Taurus?
there is no drive shaft it's front wheel drive
1948 ford drive shaft infohow do you remove the shaft.?
No proper man wants to be without his shaft
How do you remove the governor on a 98 ford Crown Victoria?
The 1998 Ford Crown Victoria does not have a "governor" The computer has a rev limiter / speed cap that keeps the RPM's below the critical velocity for the drive shaft. This prevents the drive shaft from flying apart.
How do you replace the pickup coil on a 1995 Ford Taurus?
remove the distributer, remove the roll pin holding the drive gear onto the distributer shaft, remove the distributer drive gear, remove the shaft from the distributer to gain access to and remove the stator(pick-up coil). Replace the stator, and reassemble everything.
Where can you get a tool required to remove the bolts from drive shaft of 97 ford f150 4x4?
auto parts store or sears
Can you drive a Ford 4 wheel drive truck we no back drive shaft?
of corse you can
How do you remove a flywheel from a 1999 ford ranger?
How do you remove the flywheel on a 1999 ford ranger
Where is the drive shaft?
where is the driveshaft on a 2005 Ford Ranger
Where is the rear differential plug on a 1999 ford expedition?
The rear differential plug is located on the inside top part of the differential. Where the drive shaft connects.
How do you remove a ford territory tail shaft?
you move it
How do you remove a drive shaft carrier bearing on a 1985 ford f150?
to remove carrier bearing, u will need to removbe the drive shaft from the vehicle the carrier bearing is bolted to chassis with 2 bolts . these will need to be removed and the carrier and bearing will come out with the drive shaft one drive shaft is out you can then knock old bearing and carrier off of shaft with a hammer. the old carrier is no good so doesnt matter if you trash it once you get old one off, carefully known new one onto shaft until seated,being careful to note which is front of carrier bearing you can then reinstall cariier bearing and drive shaft to truck. NOTE: now is a good time to check and replace if needed the U-Joints on the drive shaft
How do you change the flywheel on a 1994 Ford Ranger slt with a 5-Sp manual transmission?
support rear of engine. remove drive shaft. remove transmission. remove cluth. remove fly wheel. reinstall is exact opposite of removal
