1. Remove the two screws that hold the armrest in place and remove the arm rest. 2. Use a screwdriver to work back the door panel around the window crank so you can locate the metal clip that holds the window crank on. Be carfeul not to damage the door pamel 3. The metal clip looks like a U-shape and rests in two slots on each side of the window crank. Use any type of hook or needle nose pliers to get the clip off. 4. Around the perimeter of the door panel are white tabs that hold the door panel to the door. Pull on the door panel and they will pull out of the door. It is likely that a few of these may break, so you may want to buy more from an auto parts store. 5. Once all the tabs are off lift the door panel off the door. 6. To replace the door panel press the tabs into the door. 7. The easiest way to replace the window crank is to place the metal clip on the crank so it is just about to lock into the slots. Push the crank onto the shaft and then use a screwdriver to press the clip in. 8. Replace the armrest and you are done.
How to remove a bad radiator from a 1992 GMC jimmy 4x44-door,v6 engine?....Thank you :)
take off door panel, remove window, remove window sash, unlatch the lock, take the catch pin off, slide out.
take the door panel off to expose speaker
spark plug gap for 1994 gmc jimmy
The fuel pump for the 1994 Jimmy is in the tank.
Remove door panel and replace latch mechanism
remove your door panel remove the rubbers grommets, remove 3 10mm nuts unplug if power, reverse process
remove door panel on a 2002 gmc truck
The air door actuator on a 1998 GMC Jimmy is located in the dash. It is located behind the glove box.
On the 1996 GMC Jimmy, it is in the Glove compartment. There are 3 relays in there. May not be the sme on the 1994 but, this may be a good plave to look.
unbolt the door panel for rear, or loosen clips on front doors. then pop off and there ya go
near the intake.