answersLogoWhite

0


Best Answer

1.Disconnect negative battery cable 2.If equipped with tilt steering column,tilt the column all the way down 3.Remove the steering column covers 4.Remove the screws at the top and bottom of the instrument cluster bezel and detach it from the vehicle 5.Detach the bolster cover by pulling it straight out then remove the bolster bracket by unscrewing the bolts 6.Remove the end cover from the end of the instrumental panel,then remove the screws from the end of the panel and the two underneath,at each end of the knee bolster.Once the bolster has been removed,the reinforcement behind it can be unbolted 7.Remove the center cosole. 8.Pry the dashboared light control out of the bezel.Remove the screw in the light control opening and at the base of the bezel.Detach the bezel and pull it out,then disconnect the electrical connectors and remove bezel 9.Open the glove box door and remove the retaining screws,remove the screws and detach the glove box housing from instrument panel 10.Disconnect passanger airbag electrical connector. 11.Remove the audio unit from the center of dashboared 12.A number of electrical connectors must be diconnected in order to remove the instrument panel.Most are designed so that they will only fit in one matching connector,but if there is any doubt mark the connectors. 13.Remove all of the bolts holding the instrument panel to the body.Once all are removed lift the panel up pull it away from the windshield and take it out throught the drivers door

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the dashboard in a 1996 Hyundai Elantra Wagon?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Hyundai 200 elantra wagon no spark?

there is two main things that will cause an elantra to have no spark the ignition coil pack or the crankshaft sensor


Where can you buy a valve cover for a 1996 Hyundai elantra wagon?

whosale parts warehouse in cali. www.partswarehouse.com


What is the radiator capacity in a 1998 Hyundai Elantra wagon?

I checked my owner's manual - it listed radiator capacity at 6L.


How do you go about changing the rear wiper motor on a Hyundai Elantra wagon?

Remove the inside panel from your Hyundai rear door. The wiper motor mechanism will be visible. Remove the wiper motor linkage. Remove the wiper motor wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new rear wiper motor.


What are car stereo wiring colour code for 1998 Hyundai Lantra its lantra not elantra or are these two the same model please help?

there's no such thing as a Hyundai ''lantra'', its elantra If it's the same as Elantra try modifiedlife.com. They got free wiring diagrams for many makes and models. Sorry. There is a Lantra. It was released in Australia by Hyundai during the late 90s. There is a sedan and a sports wagon.


What kind of transmission fluid can be used in a 1997 Hyundai Elantra Wagon?

I've yet to change mine, but I hear that you specifically need to get Hyundai brand tranny fluid. Don't use generic.


How do you fill the rear washer fluid on a 2000 Hyundai elantra wagon?

The washer fluid containter is in the cargo compartment; I believe on the right hand side. There is a little compartment that contains the washer fluid reservoir.


Where are the washer pumps on the 2000 Elantra Wagon?

they are up your azzz


How do you relieve fuel pressure on a 1996 Hyundai Elantra wagon?

1. Remove the rear seat cushion 2. Remove the fuel pump access cover 3. Disconnect the fuel pump electrical connector 4. Start the engine and wait for it to stall. After it stalls, turn the ignition off. Any residual fuel pressure in the fuel system is now relieved


Fuse panel layout 2000 elantra wagon?

check out hmaservice.com


Does the Check Engine dash board indicator relate to a specific engine part on the 97 Hyundai Elantra GLS wagon?

the check engine light comes on for many reason or many parts usally emmision related.


How do you replace a horn in a 2000 Hyundai Elantra wagon?

1.To access the horn the left front turn signal/parking light housing must be removed.On models with two horns the bumper cover must first be removed for access to the right side horn 2.Disconnect the electrical connectors and remove the bracket bolts