answersLogoWhite

0


Best Answer

there are three bolts underneath through each framerail and three screws on the fuel filler neck and also a ground strap for the tank, don't forget to unplug the taillight harness, its on the drivers side rear

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the bed from a 1991 s10?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will a 1993 S10 truck bed fit a 1991?

Yes it will.


How do you change the fuel pump in a 1999 s10 4cylinder?

Remove the fuel tank or remove the bed, your choice.


How do you remove a driver seat to a 1991 Chevy s10?

Unbolt it from inside, lift it out.


Where is the fuel pump on a 1991 2 wheel drive s10 Chevy truck with 2.8 L engine?

in the fuel tank. it was easier for me to unbolt and remove the bed to gain access to the fuel pump.


How do you remove the fuel pump on 2002 s10?

You can either remove the bed, or use a transmission jack to lower the tank. I find it easier for a shade tree mechanic to remove the bed. Either way you have to access the pump on top of the fuel tank.


How do you remove door locks on 91 s10 not the handle the small round part u stick the key in?

To remove the door locks on a 1991 S10, the door panel has to be removed. There are bolts inside that hold the lock mechanism in place.


How do you change the oil pump in a S10 pickup 1991?

how do you change the oil pump on a 1991 s10 pickup


Will a 1991 s10 grille fit on a 1989 s10?

Yes.


How many bolts hold bed on Chevy S10?

there are 8 on a 6 foot s10 bed plus the filler neck


Where is the iddle sensor on a 1991 s10 4.3?

The idle sensor on a 1991 S10 4.3 can be located at the engine bay.


What is the location of the fuel pump fuse on a 1993 S10?

the fuel pump is inside of the gas tank you eather have to drop the tank or remove the bed to get to it


How do you install a fuel pump on a 1991 Chevy S10 Pickup?

You can either drop your tank to get access to it or the easiest way i have found is to remove your bed. there are 6 bolts holding it on plus the wiring to your tail lights. 4 bolts behind the rear tire and 2 in front. after the bed is off you can use a flat head screw driver and a hammer to remove the lock on the pump then unhook your hoses and it will come right out.