Open trunk, there should be a few screws that hold tail light assembly to car. Remove screws and pull tail light assemble straight back.
open tailgate,look for two screws between light and tailgate,remove screws and pry out light pulling straight back.
IN THE TRUNK, REMOVE PANEL NEAR REAR LIGHTS. IF THE BACK OF THE BULBS ARE VISIABLE THEY ARE EASY TO REMOVE. IF NOT, CHECK FOR SCREWS THAT HOLD THE TAIL LIGHT CLUSTER IN PLACE. REMOVE SCREWS, REMOVE CLUSTER, REMOVE BULB. I HOPE THIS HELP. GOOD LUCK.
The lens assembly is held in with two screws. Remove those and the lens will pop out.
To replace the dome light in your 2005 Toyota, you will need a flat screwdriver to remove the screws and pry the dome light cover from the light. You can then access the light to change the bulb or replace the entire bulb and cover.
To remove the radio remove the mounting screws for the center console. Pull the center console off the 2005 Acura TL. Remove the rest of the mounting screws and pull the radio.
remove 2 Phillip head screws pull out bulb replace it
open tailgate and there will be two screws. upper and lower. upper by the tailgate latch.
On my 2005 Dodge Ram Daytona. I had to open the tail gate, remove the two screws on the jam next to the light assembly. After removing the assembly, there is a light bar held by six screws. After removal of these, you can select the bulb you wish to change and then reassemble to install light assembly.
Remove the 2 round plastic covers over the screws,remove the screws and pull to the outside of the vehicle.
drop the tailgate on side of bed where tailgate closes are couple of screws. thses hold the light assembly in bed. remove thse ,then remove light assembly light bulb is the able to be removed from back of assembly
should be two screws or bolts from just inside the tail gate area