The battery is under the rear seat cushion. # Push in and up on the front of the rear seat cushion. # Lift up and out on the seat cushion. # Remove the rear seat cushion from the vehicle
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm
The seat track is bolted to the floorboard. ANSWER: my 2001 Taurus had clips for the rear seat cushion where if you push the cusion twords the rear of the car then pull upward the cushion should come off...
The rear seat cushion on a 2003 Honda Civic is held on by mounting bolts. Push the seat down to reveal the mounting bolts for the seat. Loosen and remove them. Lift the seat up and out of the cabin of the car.
* Working at the front of each seat cushion push the retaining tabs in then lift up on the front edge of the cushion and release the seat cushion retaining tabs. Remove the cushion from cushion from the vehicle * Detach the retaining bolts at the lower edge of the seat back * Lift up on the lower edge of the seat back and remove it from the car
under rear seat cushion there are fuses you can remove pass side push on seat lift up cushion
Right side (passenger side) under the cushion of the rear seat. Remove the rear cushion - there are access port covers. Remove the covers and there is the pump.
Reach under the corners of the rear seat at either end, there are clips under the seat cushion on either side of the seat. Press these up and they will click and release the back seat cushion. If the release buttons are hard to find, jerk up the rear seat a little and the release buttons are easier to feel for. The cushion can then be lifted out.
It's under the rear seat cushion. Lift up the front edge of cushion and pull forward to remove the seat cushion. Check in the owner's manual.
* On fixed seats remove the bolts at base of the seat back sidecushions and detach them.Remove the two bolts at the rear of the seat cushion and detach the cushion assembly.Remove the two bolts at the base and remove the seat back * On folding seats remove the two bolts at the front of the seat cushions and detach the cushion assembly.Fold the seat backs forward remove the bolts and lift the assembly out
Depending upon what year, it is typically under the rear seat on the driver's side. You should disconnect the negative terminal on the battery first and then remove the seat cushion bottom from the driver's side rear seat. Depending upon what year, it is typically under the rear seat on the driver's side. You should disconnect the negative terminal on the battery first and then remove the seat cushion bottom from the driver's side rear seat.
With reasonable force, lift the cushion from the front and bottom - about one foot from both ends.