Rear Axle Axle Shaft, Bearing and SealRemoval & Installation Ford 8.8 Inch and 9.75-Inch Ring Gear # Raise and safely support the vehicle on jack stands. # Remove the wheels from the brake drums. # Place a drain pan under the housing and drain the lubricant by loosening the hosing cover. # Remove the locks securing the brake drums to the axle shaft flanges and remove the drums. # Remove the housing cover and gasket. # Remove the side gear pinion shaft lock bolt and the side gear pinion shaft. # Push the axle shaft inward and remove the C-locks from the inner end of the axle shafts. Temporarily replace the shaft and lock bolt to retain the differential gears in position. # Remove the axle shaft with a slide hammer. Be sure the seal is not damage by the splines on the axle shaft. # Remove the bearing and oil seal from the housing. Both the seal and bearing can be removed with a slide hammer. # Two types of bearings are used on some axles, one requiring a press fit and the other a loose fit. A loose fitting bearing does not necessary indicate excessive wear. # Inspect the axle shaft housing and axle shafts for burrs or other irregularities. Replace any work or damage parts. A light yellow color on the bearing journal of the axle shaft is normal, and does not require replacement of the axle shaft. Slight pitting and wear is also normal. # Lightly coat the wheel bearing rollers with axle lubricant. Install the bearings in the axle housing until the bearing seats firmly against the shoulder. # Wipe all lubricant from the oil seal bore, before installing the seal. # Inspect the original seals for wear. If necessary, these may be replaced with new seals, which are pre-packed with lubricant and do not require soaking. Install: # Install the oil seal. # Remove the lock bolt and pinion shaft. Carefully slide the axle shafts into place. Be careful that you do not damage the seal with the splined end of the axle shaft. Engage the splined end of the shaft with the differential side gear. # Install the axle shaft C-locks on the inner end of the axle shafts and seat the C-locks in the counterbore of the differential side gears. # Rotate the differential pinion gear until the differential pinion shaft can be installed. Install the differential pinion shaft lock bolt. Tighten to 15-22 ft. lbs. (20-30 Nm). # Install the brake drum on the axle shaft flange. # Install the wheel and tire on the brake drum and tighten the attaching nuts. # Clean the gasket surface of the rear housing and install a new cover gasket and the housing cover. Some covers do not use gasket. On these models, apply a bead of silicone sealer on the gasket surface. The beat should run specified lubricant to bring the lubricant level to ½ in. (12.7 mm) below the filler hole.
On the top of the truck
how do you remove the right rear axle on a 1998 ford expedition?
3.31 / 3.55 / 3.73
where is located ford expedition 1999 relays
take the axle out
how to remove rear axle from 1988 f250 ford
how do you remove the grill from a 2008 ford expedition?
You can view the 1999 Ford Expedition owners manual online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides The manual includes the instructions and pictures
My alarm in my 1999 Ford Expedition won't disarm. What do i do.. Lynn
5W-30 ( according to the 1999 Ford Expedition Owner Guide )
5W-30 ( according to the 1999 Ford Expedition Owner Guide )
No , a 1999 Ford Expedition has ( 5 ) lug rims