Machete.
The Windstar will seat 7 people - 8 if there's a bench seat in the middle position if they're skinny enough
On a 2003 Ford Windstar : The cargo area is behind the rear seat
Depends on how many of my daughters are with me... ;) The Windstar will properly seat 7-8, depending on the seats in the middle section. Ford offered a bench seat, 3 people, or 2 Captains chair (connected with a console, or 2 separate units)
Use the seat belt and buckle up.
Unplug it now! Our 2002 Windstar LX almost burst into flames this morning because the malfunctioning Driver's seat drive motors shorted out! Take Windstar to Ford and have the undercarriage framework replaced before yours also overheats and starts a fire.
I have a 96 Windstar and the seat is out of it and in my spare bedroom closet. Exactly what bolts are you looking for? Will help if I can.
== == The seats come out. Look at the floor and find the release locks. By using the seat release mechanism, the rear seats of the windstar come right out of the van, leaving a complete open space for carrying loads.
No - because from the factory bucket seat vans have an extra set of floor anchors that the bench van will not have. Answer In my 2001, there are both sets of floor anchors in the middle seat position to accommodate both style of seat anchors.
To remove the rear seat from a 1989 Ford Laser 4 door car, first remove the bolts anchoring the rear seat to the floor of the vehicle. Then, lift the bottom portion of the seat from the car. Then, remove the internal bolts from the hatchback or trunk of the car to remove the seat back.
To remove the back seat on a 1989 Ford Thunderbird, the first step is to remove the back of the seat. The back is held in by bolts on each side. After the back is removed, the seat area should come out after removing the floor bolts.
The 1999 Ford Windstar owners manual shows : In the Power Distribution Box ( located in the engine compartment beside the battery ) * maxi fuse # 104 is a 40 amp fuse for the LH Power Seat Motors and LH Power Lumbar Motor *