2000 Ford Ranger Answer There is a thin plastic cover over the window crank handle. It pops out at the large end of the crank (the bottom) and will rotate out of the way so that you can get at the torx screw. The torx screw holds the handle to the shaft. It goes through the center of the shaft. You can use a flat screwdriver to gently pry the cover away from the large end of the crank handle. No special tool is needed. Once you have the handle off remove two other screws, one at the bottom of the door panel and one in the door arm rest. Then grasp the panel at the bottom and slide up to remove. There are no snap pins holding the panel in place. It slides up and off of the door latch for removal.
A flat head screw driver to pop off the plastic cover, and a star screw driver to remove the whole thing.
Their is a special tool to remove manual crank window cranks and it will work for almost any car. You can pick one up at auto zone
should be an Allen head or torx screw in the center of the crank.
Remove the inside door panel of your 1997 Chevy Lumina. Remove the linkage to the window crank. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
You will need to remove the inside door panel of your 1977 Chevrolet blazer. Remove the window crank linkage. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
You would need to remove the window regulator, and the motor. Replace them both and drill a hold through your door panel where the crank will come out.
You should be able to do it with a paper clip, but to be sure, go to the library and check-out a manual for your model of truck. We had to do this with my husbands honda. There is a pin that holds the crank on and you should be able to bend the paper clip into a hook and slip it behind the handle to find the pin and pull it out.
remove the clip retaining crank to the regulator shaft, this requires a special tool available at most parts houses.
To remove the window knob,you need to purchase a tool at any auto parts store, you would then slide the tool behind the window crank and simply push out the clip that holds the window lever in place.
How do you remove the manual window cranThere should be an Allen type set-screw in the base of the handle. It will be recessed, and you'll have to turn the crank to access it more easily. Remove the setscrew, and the handle slips off of the stud. If the window is down, and it begins to rain, you can roll the window up by holding it onto the stud, and turning, or you can use a small pair of vise grips. Just try not to damage the teeth on the stud.
You need to remove the window hand crank with a window hand crank removal tool.
How to Remove or Install Car Window Crank Handles check related link below