1 and 11/16 inch
how to remove and replace transmission fluid pressure switch on a 2002 dodge ram 1500
take the bolts out id reckon
If equipped, it is on the passenger side front of the engine.
Remove the ligth assy and unscrew it from the rear.
it is in the fuel tank, you have to remove the tank or the bed of the truck.
Front axle is 75w90 Trasnfer case is ATF+4
Should be in front of the fuel tank under the truck on the driver side.
Remove the two bolts and use a screwdriver against the hub and caliper.
remove the two light lens be careful not to break them. then remove the two torx screws behind the lens. give a slight pull down on the front of the console to remove the two clips and you are done.
1 11/16 inch
I have never heard of a mixer on a dodge truck.