First remove the Window Crank Handle. Then remove all of the screws you can find, 1 for the door release, 1 for the door grip, and 4 for the door panel. Pop loose all of the lower door area, and carefullyremove the door panel. Remove the plastic behid the door panel, SAVE IT!!. With the window all of the way down, remove the screws that hold the window in and remove the window. Revers to reinstall, being sure to locate the new window into the grooves for that.
The two way switch in your console is dirty. Remove it, disassemble, clean the contacts and reinstall.
The 1998 VW Jetta drivers side power window relay switch can be found inside of the drivers side door. You will need to remove the drivers side door panel in order to access the power window relay switch.
Remove the 1997 Chevrolet Suburban drivers side door panel. The window mechanism will be visible. Place the new window into the window track. Secure the window to the track.
You can find the window relay switch inside of the drivers side door. You will need to remove the drivers side door panel in order to access the window relay switch.
Remove the 2002 Ford Explorer drivers side inside door panel. The entire window mechanism will be visible. Locate and repair the cause for the window malfunction.
You can find the 1994 Pontiac Firebird window relay switch inside of the drivers side door. You will need to remove the drivers side door panel in order to access the window relay switch.
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
Remove the drivers side inside door panel. Remove the retaining clips from the window track. Place the new window in the window track and tighten the retaining clips.
Begin by removing the inside door panel. Remove the wiring harness from the electric window regulator. Remove the window regulator retaining screws.
Remove inside door panel, remove mirror assembly holding bolts, unplug electrical connection and reinstall.
The 1991 Toyota Corolla power window relay switch is located inside of the drivers side door. You will need to remove the drivers side door panel in order to access the relay switch.
1. Remove door panel, and disconnect the door harness. 2. Unbolt window from the rail, remove the window from the door. 3. Unbolt old motor and remove. 4. Using a window motor tool, (if you don't use one you could risk having the lifting frame on the motor uncoil and injure your hand or wrist), remove the motor from the lifting frame. 5. Using the supplied hardware install the new motor into the frame. 6. Install new motor in the door. 7. Reinstall the glass. 8. Reconnect the harness.(make sure window works) 9. Reinstall the door panel.