Take your hand and pull the center cover ( HORN PART ) off. You will see a big nut
In the center of the wheel, it may have a snap ring that you will need to pop off with a screew driver first, then remove big nut. You will now need a steering wheel puller.
Most part stores will rent it to you. When you get the puller look at the center ou the wheel where you took the nut off and to the side of the nut you will see a small threaded hole on each side. You will have to get 2 long bolts that will screew into those holes, they will go through the puller, and into the sterring wheel.
Then start tighting the big bolt that came with the puller, and it will pull the wheel off.
How do you remove the steering wheel on a 1998 Chevy astro van
do I remove steering wheel to change out ignition
Removing the ignition key switch from a 1998 Chevrolet truck is a relatively straightforward process. Before beginning it is important to make sure that the truck is off and the battery has been disconnected. To begin you will need to remove the steering wheel by first removing the center wheel nut with a 12" socket and wrench. You should then use a steering wheel puller to remove the wheel. Once the wheel is removed the ignition key switch will be visible in the center of the steering wheel. To remove the ignition key switch you will need to remove the retaining clip and then unscrew the bolts securing the switch in place. After the bolts have been removed the switch can be removed and replaced with the new one.
cut the cheese
there should be a couple of bolts on the back side of your steering wheel that removes the front face and after you take that off there will be a large nut that will take off the rest of the steering wheel, but remember to disconnect the airbag before you remove the steering wheel cause you could set it off.
You need to undo the two locking pins on the side, then take the steering wheel off, only in a straight angle. Dont forget to remove the casing aroung the steering column
If the key is stuck in your 1998 Mazda 626, the steering wheel column may be locked. To remove the key, adjust the steering wheel and turn it clockwise to the proper position. Then try removing the key.
The steering wheel cover on a 1998 Cadillac SLS is not secured with bolts or anything so it just takes force to remove it. It will not break so do not be afraid to use some strength to get it off.
There are two small access holes on the backside of the steering wheel. They are a torx head, remove these screws (screws will stay inside of steering wheel, but must be loosened all the way) then pop the airbag off. You then will have a big Allen head nut holding the steering wheel on the steering shaft. Remove the nut and the steering wheel comes off.AnswerAnd if you actually did mean -move wheel- rather than -remove wheel - not all the cars have a moveable steering wheel. As I recall, it was an option to have one that fully tilted and some packages only came with a height adjustable one. In both cases there is a lever near or along the steering column that allows the adjustment.
to remove pump on 1997 Bonneville, I aligned holes on actual pulley wheel access holes and reversed bolts.........
Have you checked the steering wheel?
The 98 escort zx2 did not come with a tilt steering wheel