Want this question answered?
If you have an electric side mirror you have to remove the door panel then unplug the electrical connector and then remove the screws that hold the mirror.
Remove the inside door panel from your 1991 Chevrolet 1500 pickup truck. Remove the wiring harness from the mirror. Remove the driver side mirror retaining bolts. Reverse the process to install the new driver side mirror.
Make sure all the clips and screws are out of the panel. Roll the window down, lift upwards on the end of the panel closest to the door lock while pushing the top of the panel in, towards the window. The top of the panel sits in a channel next to the window and you have to dislodge it out of the channel. Go to this website. It will show how to remove the door panel & the side mirror.
# Disconnect negative battery cable # Remove all door trim panel retaining screws and door pull/armrest assemblies if equipped with power mirrors remove the switch knob by pulling it straight back and remove the switch retaining nut # Remove the window crank insert a putty knife between the trim panel and the door and disengage the retaining clips.Work around the outer edge until the panel is free
From what i know you have to remove the door panel and tighten the 3 bolts holding the mirror
FRONT DOOR TRIM PANELREMOVALRelease door latch and open door.Roll window down.Remove window crank , if equipped.Remove screws holding door trim panel to door from inside arm rest pull cupDisengage clips holding power window/lock switch panel to door trim panel Disengage wire connectors from switch panel, if equipped.Remove screw holding door trim to outside mirror frame.Using a trim panel removal tool, disengage clips holding door trim to door around perimeter of trim panel.Disengage power mirror wire connector, if equipped.While holding bottom of trim panel away from door, simultaneously lift upward and forward.Separate door trim panel from inner belt weatherstrip.Disengage power outside mirror wire connector from control switch.Separate door trim panel from vehicleINSTALLATIONReverse the preceding operation.
debajo panel de instrumento
Remove the door panel.Unplug the connector to the power mirror.Remove the three bolts from the mirror base.
The retaining clip on the end of the post that the switch is located on - how do you remove it?
You will have to remove the entire door panel to get at the screws that hold the handle assembly to the panel.
A switch bezel on the drivers inside door panel of a 2013 Chevrolet Silverado 1500, 2500, 3500 and a 2013 GMC Sierra 1500, 2500, 3500.
might be a bad or loose wire on the headlight switch,or the switch itself may be going bad