To remove the fog lamp, you would simply need to remove the cover next to the fog light. You can remove the screw that's under the cover and other side that's held in by a clip.
how do i remove and replace my fog lamp bulbs on my 2006 bmw 525i
Remove the two torque type mounting screws from the headlamp and gently move the headlamp out of the way, Power cable to headlamp can be removed but not needed. Easy access to fog lamp bulb is then achieved. Disconnect fog lamp power cable and twist bulb to remove.
The lens is only available as the whole fog lamp. You have to remove the bumper to replace it.
You have to remove the wheel well lining to have access.
"i believe you have to change the entire fog light assembly." Wrong Answer. Correct Answer: Remove the wheel well splash guard to access the fog lamp assembly. Twist the harness and remove the old bulb. Replace bulb. Twist harness back into fog lamp assembly. Replace the wheel well splash guard. Done.
To access the fog lamp for replacement (which runs about $90 each) you need to remove the splashguards in front of the tire. With that removed you can easily reach the lamp for replacement. Simple matter of taking out four screws and reinstalling the new one.
Remove the headlight directly above the fog light,you can reach down easily to access the lamp
To remove the fog lamp bulb just pull the plug off the back of the bulb and turn the bulb one quarter turn and it will come out. To remove the high brake lamp bulb you need to carefully pry the plastic cover off then there are two Phillips screws that remove the whol lamp assembly then just pull out the bad bulb and replace
Remove the rock guard behind the bumper to allow access to the back of the lamp in the bumper. Unhook the wiring harness from the lamp, and it will be a quarter turn to remove. Common bulb, can purchase anywhere.
To install fog lamps on a 1968 Mustang you will need the following items: 1968 Fog Lamp Wiring Kit C8ZZ-15223-FUD FOG LAMP BAR BRACKETS C8ZZ-15266/7-A FOG LAMP BULB FDU-15220-A FOG LAMP HOUSING ASSEMBLY C8ZZ-15200-AC FOG LAMP SWITCH C8ZZ-15A214-A source: AAPD.net
Assuming this is for one of the 2 rear fog lamps, then remove the three bolts from the rear lamp housing. The fog lamp is the bottom bulb in the set. Give the bulb holder a quarter turn anti-clockwise and remove the bulb and holder from the lamp housing. The bulb is held in place by a plastic clip either side. Spread the clip sideways slightly and the bulb will pull out. Put new bulb in and replace.