Remove the 2002 Dodge Durango factory stereo decorative cover. Remove the factory stereo retaining screws. Pull the factory stereo out. Remove the wiring harness and the antenna cable from the back of the stereo.
go to0 a stereo shop and buy one and have it installed go to0 a stereo shop and buy one and have it installed
there will be roughly 4 screws on the dash, 2 by the guage window and 2 by the radio/ heat controls. after removing pop out the dash. you will have to lower the steering collum, after the dash is off you have 4 screws holding the stereo in place.
The 2002 Nissan Pulsar Factory Stereo wiring diagram can be found in the maintenance manual. It can also be found in the cars repair manual.
No.
remove the plastic panel around the stereo by using a flat screwdriver to pop it out in all corners then remove screws then remove stereo remove the plastic panel around the stereo by using a flat screwdriver to pop it out in all corners then remove screws then remove stereo
THE FACTORY AMP IS LOCATED UNDER THE DASH BORD PASSENGER SIDE THERES ONE SREW THE PANEL COMES OFF AND THERE IS THE AMP 2001 DODGE DURANGO
Watch the following video. It give a clear step-by-step overview of the process. http://www.youtube.com/watch?v=hlp2KuWpoFI
Non-factory installed radio? Installer might have used that circuit for memory on radio
No.
How do I install my output converter to my factory stereo in my car
The cover surrounding the stereo just clips on, give it a good pull toward you and it will pop off, the stereo will be right there...
No, have to use line-out converters.