answersLogoWhite

0


Best Answer

It's not impossible at all, its just takes some patience and some trust in yourself. All you have to do is remove the two screws that are located 1)Inside the doors armrest area and 2)Under the little cap covering the other under the door handle. You may want to use an flat screwdriver to remove the cap. When you remove those two screws start working your way around the edge of the door(where the plastic meets the metal) with a wood putty knife or something wide and flat. DO NOT TRY TO PULL FROM THE ARMEREST AT ANY POINT!!! Yes it will break off!!! When you begin to work your way around, feel for pressured areas. These areas have plastic fastners that hold the door panel on and help keep it in place. But when you remove them, you'll hear a loud "pop" noise. Its the fasteners coming out of their holders. On the front drivers side there are about 9 to 10 of those fasteners and two sliding fasteners at the top. On the passengers front panel there are No sliding fasteners and about the same amount of pop fasteners.

User Avatar

Wiki User

βˆ™ 9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove a door panel of a 2002 Jeep Liberty?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a 2002 Jeep Liberty have a timing chain or belt?

A 2002 Jeep Liberty has a timing chain.


How hard is it to remove and replace the heater core in a 2002 Jeep liberty?

how hard is it to replace the heater core in a jeep liberty limated editon step by step instructions


Jeep Liberty 2002 radiator fan not working?

how do you chage the fan resistor in a 2002 jeep liberty?


What sends power to plugs on 2002 jeep liberty?

What distributes power to spark plugs on 2002 jeep liberty


What type of transmission fluid for a 2002 Jeep Liberty automatic?

A 2002 Jeep Liberty uses ATF+4.


Can you install 2005 Jeep Liberty engine on 2002 liberty?

the answer is no. 2002 was the first year the liberty was made. in 2003 they change the computer modules..the only engine you can put in a 2002 jeep liberty is a 2002 engine


Does it need to remove thermostat on the 2002 Jeep Liberty using in hot country?

You should never need to remove the thermostat and leave it out.


How do you change the front brake rotors on a 2002 Jeep Liberty?

You will need to remove the front tire and wheels from your 2002 Jeep liberty. Remove the brake pads and break assembly. Tap the rotors with a hammer or mallet. The rotors will come off. Reverse the process to install the new rotors.


What kind of lifting fixture do you use to remove the 3.6l engine in a 2002 jeep liberty?

The dealer has a special tool for that.


Where is the location and how to I get to the Jeep liberty 2002 Carbureator to clean it?

there is no carb on the 02 jeep liberty, it is efi.


Where is the IAT sensor located in a Jeep Liberty?

Where is the speedometer sensor located in a Jeep Liberty 2002?


2005 Jeep Liberty fuse box?

driver side on left side of dash/steering wheel - remove panel on side