answersLogoWhite

0


Best Answer

This is done very easy.Pull the trim around the radio.It will pop off.Push the trim peice to one side.You will see four screws,two at the front and two near the back off the radio.Remove these and the radio is out.Make sure you know your code before you unplug the radio.The radio lock out once you remove the plug.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove a 2004 Pontiac vibe stereo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change starter on 2004 vibe?

Remove the positive cable from your 2004 Pontiac Vibe battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.


The average price of a used 2004 Pontiac Vibe is?

One can purchase a used 2004 Pontiac Vibe from CarMax for $10,998. The AutoTrader website states the price of a used 2004 Pontiac Vibe ranges from $7,025 to $7.450.


Where is the alternator on a 2004 Pontiac vibe?

under the hood


Where is the heater relay on a 2004 Pontiac vibe?

Its in the glove box


How many gallons does a tank on a 2004 Pontiac vibe?

13.25


Where is the blower motor resistor located on a 2004 Pontiac Vibe located?

passenger side under glove box...you don't have to remove glove box to get to it...generation vibe forum has clear photos


How much oil in a 2004 Pontiac vibe?

4 quarts of oil.


What is the Spark plug gap 2004 Pontiac vibe?

Gap is .044


Where is the thermostat located on a 2004 Pontiac Vibe?

It is located on the engine block where the upper radiator hose connects to the engine. To get at it you need to remove the serpentine belt and alternator.


When was Pontiac Vibe created?

Pontiac Vibe was created in 2002.


How do you remove the center console in a 2009 Pontiac vibe or Toyota matrix?

VERY carefully....:)


How do you replace Pontiac vibe front wheel bearings?

The front wheel bearings, of a Pontiac vibe, can be replaced by first removing the front wheel. Next, remove the axle end cap. Remove the bearing and reverse the process to install the new bearing.