There are a few ways to this. You can take the window out or leave it in.
1.) remove the door panel and pull back the sticky paper.
2.) After you do this, push the window up, clean the class and clean the two clips on the aluminum arm
3.) Use a silicon or if you want an epoxy to fill the two clips the window sits in and lower the window back into these two clips.
4.)use the window button to close the window and let the epoxy or silicon cure. I usually wait 1-2 days.
5.) You should be good to go until the next time it happens
Replace driver's switch assembly
How do I replace the washer on my 200 Continental? Don
The window motor on a Lincoln Continental is replaced by removing the door trim, disconnecting the wiring harness to the motor, and unbolting it from the door. A new motor can then be mounted and hooked up.
i know the rear window relays are in the trunk, on the backside of the back seat. there are 4 of them.
You do not reattach any mechanism. You will have to replace the window regulator.jd
well, if my calculations r correct, behind the dashboard
The window is not off track. The window regulator is broken. In most cases you will have to replace the window motor and regulator as an assembly.
Remove the inside door panel. You will be able to see the entire window mechanism. Remove the obstruction that is keeping the window from closing.
You can find various parts for these vehicles on Ebay. Also Lincoln Land in Florida may have what you need as well.
Remove the inside door panel of your 1988 Lincoln Town Car. Remove the wiring harness from your window motor. Remove the window motor retaining screws. Reverse the process to install a new window motor.
"http://wiki.answers.com/Q/How_do_you_remove_drivers_side_front_window_switch_panel_in_a_2003_Lincoln_Town_Car"
GENTLY!. You will have to pry up wood grain panel on window switch, cheapest way is to visit local junkyard and scavenge the switch, 2 bucks, but if the wire between the door and front end is cracked inside the accordion tubing you ll spend extra time replacing it. Good Luck.