if you have aftermarket stereo it is very easy pull the stereo out of the dash and take your rca wires and plug them in to the back of the stereo and then take your blue wire which is remote wire and conect it to the remote wire on the back of the stereo, from there you rum the wires to your amp. ground the amp and hook up the sub to the amp and you are good to go. hope this helps.
A passive subwoofer doesn't have a built-in amp and will require the use of an amp.
The amp is right next to the subwoofer. They are both located behind the rear driver side panel.
You can get an 18" Pyle subwoofer but you will also need a large amp for it.
You must first check with the guide to your subwoofer. Either you can probably find it online , but you need to know the RMS wattage for the subwoofer. Than buy an amp that can put out the same number of watts and the RMS is for the subwoofer.
It depends on the power rating of the subwoofer.
Yes a subwoofer can be plugged into a stereo without an amp but it wont sound good and wont hit anywhere near as hard as if you had it runnin through an amp... get an amp
no of course not you idiot
in fact , some subwoofer with amp. you don't need buy amp. give you one good guide http://www.12vcity.com
Yes, you can use a 500W subwoofer with a 1000W amp. Just be cautious not to crank up the volume too high to avoid damaging the subwoofer. Make sure to properly set the gain levels on the amp to match the subwoofer's power handling capabilities.
Under the instrument panel..Its a 15 amp one...
Wire the subwoofer to and AMP and the amp has to be directly hooked up to your battery. There is a second wire that is hooked up to a wire that only has power when the keys are turned. This turns the Amp on by turning on a relay in the amp powering the sub. And connect the ground to something steel in the car.
Please be more specific and state whether or not you are going to install an amp or clarify that it is just a subwoofer.