0
Have you done a rebuild? Is this why your trying to purge the cooling system? Typically you will need to run the vehicle till the temp gauges reads near overheating, then allow the vehicle to nearly cool and remove the radiator cap. This allows air pockets to be pushed through the system. You can also run it to normal operating temperature and slowly crack the radiator cap allowing the system to expell excess pressure.
Add your answer:
Earn +20 pts
How do you put serpentine belt on a 1990 ford bronco with a 5.8 engine?
how do put belt on 1990 ford bronco 5.8
Will a tailgate of a 1990 ford bronco fit a 1996 ford bronco?
yup.
Where is the voltage reg. on a 1990 bronco?
it is in the alternator
How do you flush the heater system in a 1990 Thunderbird?
put cooling system flush in the radiator and follow the directions but make sure the heater is on while you do it.it will clean both your cooling and heating systems.
Where is the map sensor locatedon a 1990 ford 5.8 efi bronco?
The map sensor on a 1990 Ford 5.8 EFI Bronco is on the passenger side. It is located on the firewall.
Does a 1990 Ford Bronco II take R-12 or R-134 for the air conditioning system?
R12 ( unless it has already been retrofitted )
How much would it cost to fix the cooling system on a 1990 Honda Accord?
That would depend on what problems you are having.
Will a ford 460 fit in a 1990 ford bronco 2?
No
How much can a 1990 ford bronco tow?
5000 lbs
What is the last model year of ford bronco II?
The Bronco II was made till 1990. The it was replaced by the Explorer in 1991.
In what years was the Ford Bronco 2 sold?
The Bronco 2 was sold between 1984 and 1990. The Ford Bronco 2 was a compact SUV. It was smaller than a full-sized Bronco. It was succeeded by Ford Explorer.
Where is the cooling system bleed valve of the 1990 Honda Accord EX?
Bleed valve is located on top of thermostat housing.
