answersLogoWhite

0


Best Answer

1. Close all the vehicle doors.

2. Insert the ignition key into the ignition lock cylinder.

3. Press and hold the door unlock switch.

4. While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.

5. Release the door unlock switch. The doors will lock and unlock to confirm the program mode.

6. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.

7. Repeat the previous step to program up to 4 transmitters.

8. Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter programming mode.

9. Operate the transmitter functions in order to verify correct system operation. b0i13r

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you program a key remote for a 2004 GMC Envoy?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you program gm keyless entry remote 1999 gmc envoy?

how do you program keyless entry remote 98 GMC


How do you program a key remote for a 2005 GMC Envoy?

The procedue is documented in the ownwer's manual.


Como programar un control remote de una 2004 gmc envoy?

Check


2004 gmc envoy with code po128?

2004 gmc envoy with code p0128


How do you program a 2007 gmc envoy remote?

To program a 2007 GMC Envoy remote, close all the doors. ?æInsert the key in the ignition while holding the unlock button on the drivers side. Turn ignition from on to off twice. ?æNow release the unlock button. ?æThe fob is ready to program.


How do you replace wheel bearings on 2004 GMC envoy?

how to replace wheel bearings on 2004 GMC envoy?


How do you remove the radio from a 2004 GMC Envoy?

2004 GMC Envoy is on page 28 http://documents.victorytechnologies.com//documents/product/929.pdf 2004 GMC Envoy is on page 28 http://documents.victorytechnologies.com//documents/product/929.pdf


How do you remove fan shroud on 2004 gmc envoy?

How do you remove the fan shroud on a 2004 get envoy


Where is the ac recharge port on a 2004 gmc envoy?

The AC recharge port on a 2004 GMC envoy is on the low pressure connection. It is the larger of two hoses near the firewall.


How do you program a keyless remote for a 2000 gmc Yukon?

How do u program a keyless remote for a 2000 GMC Yukon


Does the transmission on a 2004 gmc envoy have a filter?

Y Yess


How do i program the remote control for garage in a 2003 gmc envoy?

This one is pretty easy. Press the button in the envoy that you want to program as your garage door opener until it starts blinking rapidly then press you original garage door opener while you are still pressing the program button. Hold like this for a couple of seconds and the button in the envoy should be ready to go