0
Open the glove box, reach in and remove this little book called an Owner's Manual. Inside this little book is all kinds of answers to this and many other questions. You will find it invaluable for future reference.
AnswerYou have to take it to a dealer, the service department has to program those. Answerthe guy with the first answer is trying to be funny. but hes not. u gotta go to the dealer and theyll take the serial number and program it there. its not a do-it-yourself type of thing.All these answers are wrong. It deals with a sequence of electrical input from the car such as placing the ignition in the on and off position several times. The exact sequence is different and with research on the net you can find it. Only in rare instances does the car need a special "adaptor" along with the sequence to program it. Good luck finding it.
AnswerThe only wrong answer is the one above. The manual does discuss programming additional remotes. However, if it is the only remote you have and you need it programmed then you must take it into a dealer\automotive electrician to program it. No ifs, buts or maybes.It is possible to do yourself with a small amount of technical skill. You must locate the data link connector under the driver's side of the dash. You must connect pins 1 and 4 with a small wire or jumper. This tells the system it is ready to be reprogrammed. Close all doors. Turn ignition switch to ACC. then back off. The door locks will lock/unlock as a signal the system is ready. Push any button on on each keyfob to be programmed. They must be pressed within 1 minute of each other. The doors will lock/unlock to signal the codes were recieved. Remove jumper wire and enjoy your remotes.
Add your answer:
Earn +20 pts
How much does the dealer charge to program a 2004 dodge stratus keyless remote?
one hr of labor like $45.00
How do you program a 1994 dodge intrepid Keyless remote?
how do you program a keyless remote for a 94 Dodge Intrepid. I battery died and now the horn keeps going off
How do you program a 2005 dodge caravan keyless remote?
Dealer item.
How do you program a keyless remote for 2006 dodge ram?
With the dealers scan tool.
How do you program keyless entry transmitter to dodge 2500 ram pickup?
You can't program the keyless entry remote for the Dodge 2500 yourself. You have to have it done at a Dodge Dealership. The cost is around $75.
How do you program the keyless entry remote on 1999 dodge durango?
With the dealers scan tool.
Where is the alarm reset button on a Dodge Journey?
On your keyless remote.On your keyless remote.
How do you program a keyless remote for a 2001 dodge ram 1500?
It requires the dealers scan tool.
How program a keyless entry remote for a dodge?
That requires a scan tool. Usually a trip to the dealer.
How do you program a 2005 Dodge Stratus keyless remote?
If u don't have a remote other than the one needing programed, u need to go to a dealer to get it done. If u need a remote, email me w/ FCC ID # on back 1st, i have a cpl that may be the one you're looking for!! Will sell cheap!
How do you program a keyless remote for a 2005 Dodge Ram 1500 if you do not have a working remote and there is nothing in pin 1 of the data link?
It requires the Dealer's scan tool.
How do you program extra keyless remotes for 2003 Dodge Ram 1500 when you have one remote that is already programmed?
You will need a scan tool to do that.
