answersLogoWhite

0


Best Answer

rotor, take on wire of old at a time and put on new one. Then take off two bolts and then put new one in place of it. Make sure you mark old one as to how it was on, to make sure new on is the same way. Brake rotor, take tire off. There should be two bolts on the back of brake. Remove. Then whole unit should come off. The remove rotor. May be some bolts, or just ready for removal. Probable going to be rusted in place if there are no bolts to remove. Use a plastic hammer, or even a peice of wood and hammer.Put on new one, and put all back together.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you install rotor on Geo Metro?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will a 93 Geo Metro transmission fit in a 95 Geo Metro?

Can you swap a 93 Geo metro manual transmition with a 95 Geo Metro


How do you remove the front rotors on a 1998 Geo Metro?

Remoce wheels Remove 2 caliper mounting bolts Slide caliper off rotor Remove rotor


How do you change Rotars on a 96 Geo Metro?

Remove wheels Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub


Who makes geo metro?

General Motors A Geo Metro is a Cheverolet geo and Chevy metro are both made by suzuki in Canada


The geo metro is by ?

The geo metro is by far is the best v8 car.


Will doors 94 Geo Metro fit a 92 Geo Metro?

yes


Will doors from a 1996 geo metro fit a 1993 geo metro?

No they will not fit. after 1994 the Geo Metro developed a new more curved body system. You can use a 1989 - 1994 Geo Metro door though.


How much horsepower does Geo Metro have?

The geo metro was a version of the Suzuki Cultus that was produced from 1989-2001. The geo metro came with a 49 horsepower engine.


How do you install a distributor in a geo metro?

The quick answer is...set motor on top dead center, put the distributer in place making sure the cross ridge of the shaft fits in the slot in the camshaft. That slot is slightly off center and the distributer will only go in one way. When you put it in place, if it doesn't go right in place without forcing it, turn the rotor 1/2 turn. Once in place, make sure the rotor points at #1 spark plug wire. Mr Geo Metro leehduncan@verizon.net


Would a 1995 Geo Metro Transmission work in a 1996 Geo Metro?

yes


Why does Geo Metro miss at take off?

why does my GEO metro have no take off power


Does a 1992 Geo Metro have an interference engine?

yes, if it's a 3 cylinder Mr Geo Metro yes, if it's a 3 cylinder Mr Geo Metro