I'm am just now doing this for my 2001 Sable. You will need an 8mm socket and probly an 8mm open/box end wrench. This is list does not have the specific details of "how to" for each item. But you should be able to find more references on the internet here and there. And the other thing is that my reference told me just two screws for the actuator, but I actually found three. All this stuff is plastic - careful pushing and pulling. Do the following:
Now it gets harder - most of this work will be done thru the hole where the radio console was, but you might also need a hand up from beneath the glove box area. Access to some of the screws is difficult inside the cramped dash area, and its really dark and hard to see.
It took me about 2 hours to go through all this and finally remove the actuator from the vehicle. It will probably take at least as long to put it all back properly.
take glove box out,pull ash tray open. Look to left of glove box opening, 4 8mm screws. Not a big job 30-45 minutes tops
If "temperature control" means the device that adjusts the heating/cooling temperature, that would be the temperature blend door actuator motor.See "Related Questions" below for more about that and other Taurus / Sable heating problems and fixes
This sounds like a temperature blend door problem - with the door stuck in the heat position. See "Related Questions" below for information on Taurus/Sable blend door actuator motors and blend doors
The little motor that drives the temperature blend door is pretty much behind the radio.See "Related Questions" below for lots more about replacing it, and volumes of additional information about Taurus Sable heating systems & fixes
I believe the "Related Question" below specifically addresses replacing the door glass on a Taurus / Sable.
Thermostats install into the housing with the spring-side towards the engine.See "Related Questions" below for more about Taurus / Sable thermostat installs.
Maybe the information for a 1998 Sable/Taurus in the "Related Question" below will help with your 1994.Should be very similar
No, a Generation 2 (1992-1995) Taurus/Sable Windshield will NOT fit a Generation 3 (1996-1999) Ford Taurus/Sable.
99% sure the Taurus radiator will be a perfect match to the Sable's.
No - the Taurus-Sable was significantly redesigned in 1996.
No. 2000 Taurus and Sable are the only interchange.
1995 Taurus - Sable front speakers are 6.5 and back are 6 x 9
Yep - 3 of the most common are:Temperature blend door actuator motorClogged / failed heater core - engine cooling systemBroken temperature blend doorSee "Related Questions" below for extensive coverage of these and other possibilities