0
remove the fan shroud the motor mount bolts, the torque bars from the tranny to engine then the 2 bolts that hold in the oil filter mount. the lower bell housing needs to be removed as well to access the back of the oil pan. the motor must be raised about 4 inches to allow the front of the pan to move. then remove the pan and there are 4 bolts and the pump and shaft come out at the same time. buy a hv pump and replace the stock shaft with the replacement with the steel shaft instead of the one with the nylon colar, Good luck! i did mine on saturday, it took a couple hours.
Add your answer:
Earn +20 pts
Does a 1999 Tahoe have a oil pump?
Yes all engines have a oil pump, It's in the oil pan.
How do you change oil pump on 97 Tahoe?
Drain the oil from the oil pan and remove it. Remove the oil pump retaining bolts. Reverse the process to install the new oil pump.
Where is the oil pump located Chevy Tahoe 1999?
Mounted on the engine block inside the oil pan.
Where is the oil pressure regulating valve located at on a 1999 Chevy Tahoe with a 5.7 engine?
It is built into the oil pump.
How do you install the oil level sensor 2007 Tahoe?
How do you install an oil level sensor 2007 Tahoe
How do you replace the oil pump on 1999 Chevy Malibu?
Drain the oil from your 1999 Chevy Malibu oil pan. Remove the oil pan retaining bolts. Remove the oil pump retaining bolts. Reverse the process to install your new oil pump.
How do you install an oil pump in a 1977 F250?
Drain the oil from the oil pan. Remove the oil pan. Unbolt the old oil pump. Reverse the process to install the new oil pump.
What happens when an oil pressure switch goes bad in a 1999 Chevy Tahoe?
Usually you will not get an accurate oil pressure reading either too high or too low. Occasionally they will leak and pump oil through the switch
How to install wirer oil pump?
No
How do you change oil pump on 1999 plymouthy neon?
Answering "How do you change oil pump on 1999 plymouthy neon?"
How do you change an oil pump on a 1999 ford expedition?
Oil Pump Removal & Installation4.6L and 5.4L Engines1. Remove the timing chain. 2. Remove the oil pan. 3. Remove the three oil pump screen and cover bolts, then remove the screen and cover. 4. Remove the oil pump screen and cover spacer. 5. Remove the four oil pump mounting bolts, then remove the oil pump from the engine. To install: 6. Clean and inspect the mating surfaces. 7. Install the oil pump and loosely install the four oil pump mounting bolts. Tighten the four oil pump bolts in sequence to 71-106 inch lbs. (8-12 Nm). 8. Install the oil screen and cover spacer to 15-22 ft. lbs. (20-30 Nm). 9. Install the oil screen and cover, then install the three oil pump screen and cover bolts. Tighten the bolts near the oil pick up screen to 15-22 ft. lbs. (20-30 Nm) and the bolts at the opposite end of the pick-up to 70-106 inch lbs. (8-12 Nm). 10. Install the timing chains, then install the oil pan.
Where is the oil pressure switch on a 1998 Chevy Tahoe with a 5.7 v8?
The pump is located in the oil pan, also with a sump pump and filter with screen.
