Sometimes installing a hub cap can be tricky. The best way is to use a rubber hammer designed for the job. Position the hubcap on the wheel, and while holding one side of the hubcap, strike the other side with the hammer. If you don't have a rubber hammer, sit on the ground and position the hubcap on the wheel. Hold one side with one foot, and using the sole of your other foot carefully kick the hub cap on. Make sure the cap is fully seated onto the rim and then attach the lock if it is equipped with one.
its on the passenger side next to the firewall
No.
10w30 says it right on the oil cap.
The p/s filler cap is below the alternater between the engine and firewall/bulkhead on passenger side of car. About 10 - 12 inches below the alternater.
no sensor,but if cap dont seal it will set code 440,fuel tank not hold vacuum.make sure the gas cap is tight,if is replace with new.
The power steering fluid dip stick is made to the reservoir cap. Pull the cap off to read the stick.
If the gas cap was in fact loose or faulty, just tighten it or replace it and the light will clear itself after a couple drive cycles.
bottom left front of motor
give it a tune up it has to be one of a few standard things it is the battery, alternator, spark plugs, distributer cap, spark plug wires, or gas
All new cars are Vacuum sensitive. The Oil cap and PCV valve are part of the vaccum system. If you have a vacuum leak this could cause the car to stall out.
Spark plug wires porous? Defective distributor cap? Defective ignition coil?
how to replace the tether gas cap on a 1998 Buick Century?