0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where would you find the universal joint in a 98 dodge durango?
They are on the ends of the drive shaft.
Dodge Durango rear drive shaft removal?
How do you remove drive shaft from a 03 durango
Where is the PCV valve on a 03 dodge durango 4.7?
The PCV value on a 2003 Dodge Durango is on the side of the oil fill shaft.
How much would a driveshaft repair cost?
Just got my 2001 dodge Durango front drive shaft on my 5.9 awd replaced $600 after tax and install from the shop.
When do you change the transmission on a 2006 Dodge Durango?
The transmission on a 2006 Dodge Durango is changed by removing the drive shaft, disconnecting the linkage, and unbolting it from the engine. It can then be lowered from the vehicle and replaced.
How do you replace the universal joint on a 1997 Dodge Ram 1500 4X4?
Mark position of drive shaft and yoke - to install in the same position (not to upset balance) Remove and discard small "U" bolts on yoke Slide drive shaft up spline end to dislodge drive shaft from yoke. You can either "beat" U join out of shaft, but better to bring to auto parts store that has a machine shop to install new joint Use new "U" bolts to install Make sure "U" joint is fully seated in yoke and installed in same position as removed
Where is the power steering control valve on a 1998 dodge durango?
the contol valve is in the housing the input shaft is connected to the valve
Is the cam shaft on 2000 dodge durango v6 same as v8?
No, the V8 cam is longer due to the extra cylinders.
Where is the cam shaft sensor on a 2000 dodge durango 4.7 liter?
It is under the front of the passenger side cylinder head.
What is the difference between a 2 joint shaft and a 3 joint shaft for a 1996 Dodge Dakota?
The joint you are looking for is the U joint. You have one at the back of the transmission and another where the drive shaft attaches to the rear end. On the extended version there will also be a U joint in the middle. So if you look under the car and the drive shaft just looks like one long tube you have a two joint shaft. If however, you see what appears to be a joint about the size of both of your fists together in the middle of the shaft, you are looking at the third joint.
How do you get the bolt on the ball joint to stay on it keeps coming loose?
install a cotter pin in the hole in the shaft of the ball joint
Where is the output shaft speed sensor on a 2000 Dodge Durango?
It is located on the rear of the transmission, drivers side. 5 minute fix...
