Doesn't have one.
When your security light comes on and your car will not start, turn you key to the on position and wait 10 minutes. The light will go off and you need to turn the key to the off position, then restart your car.
Have the problem repaired and they will reset the light. If you DIY then disconnect the negative battery cable for 5 minutes. If that does not reset the light you will have to have it reset with an OBD2 scan tool.
To reset the security light on an Oldsmobile vehicle, first the driver must turn the key to the "on" position, without starting the engine. Next, he or she should turn the key to attempt to start the engine, but not completely, so that it doesn't start before moving the key back to the "on" position. After about 12 minutes, the light will?æbe reset, and the key should be removed.?æ
To reset the fashing dash blue security light............disconnect the hot lead on the battery and after about 3 minutes, reconnect it. Light should be off now.
Well that depends on what type of security light bulb it is. Is it for your car, backyard or porch? There are so many out today.
The security light on a 2001 Chevy Astro Van can be reset by disconnecting the battery for 30 seconds. This resets the system and turns out the light until another problem is detected.
turn off engine, and start again
A 1991 Oldsmobile does not have a reset button.
Oldsmobile vehicles do not have inertia/reset switches.
If the coolant system (radiator and reservoir) is full and the light remains on, the probe on the coolant level sensor is probably dirty. Remove it from the radiator, clean it gently with brake clean and an old toothbrush, re-install it, refill coolant system and you should be good to go.
2 ways, autozone can reset the light,no charge. But they can also tell you what the code # is and what you might need to repair it. Or you can disconnect the battery for approx. 5 Minutes, that should reset the cars computer.