(STEP 1) Remove the 2 screws that are in the door handle.
(STEP 2) Using a door handle remover found at your local auto parts store for about 3 bux, or better yet, a butterknife...remove the pin holding on the window crank handle (The pin looks like a horseshoe kinda) Then remove the crank handle.
(STEP 3) Remove all the screws along the perimeter of the door panel, I think there are about 5.
(STEP 4) Now just pull the panel out and up. If you here small "snaps" it is normal because it is also held on with clips.
It has a retainer on the inside of the door. Take the door panel off.
Take the door panel off. Match the Wires.
What do I need to do to take the door panel off a 1996 Chevy Silverado? Pickup has power windows and door locks I need to fix inside door handle
i got the same car. remove the door panel there will be two screws in the inside door handle and like 6 or 5 aound the outside edge of the door panel remove all these and then pull and pop the tabs loose all around. and pull the whole panel upwards off the door
go to a junk yard and find a sunfire or a Chevy cavalier take the door panel off and unbolt the window mechanism and go home and take your door panel off and replace the mechanism
take door panel off
how i do replace the drivers side mirror for a 2002 Chevy venture with taking off the inner door panel
The interior front door panel of a 4-door is attached to the door with two screws in the arm rest, three at the bottom of the panel, one at the edge nearest the door latch, and one in a separate plastic panel near the outside mirror. Remove the screws using a Phillips screw driver, then gently pull on the panel to remove it. After loosening the panel there is an electrical connector to unplug (with electric door locks) before the panel can be completely removed from the door. Removing rear door panels or the panels on 2-door Cavaliers should be similar.
I suspect the rod that opens the door has come loose or broken off the door handle and is keeping the window from coming down. Take the inside door panel off and check. If needed just replace the door handle.
The 1985 Chevy Caprice driver side door panel is held in place with for retaining bolts and 10 retaining clips. Remove the retaining bolts. Pry outward on each retaining clip. The door panel will come off.
One screw you won't see is under the lock switch. Anywhere you find a hole there will be a screw some are just deeper than others. After you remove the screws the panel will pop off.
TAke off the left kick panel and there are bolts holding it on.