press the hazards button again
that's strange!! my 63 only has directional signals
not sure what causes it, but sometimes my signals will just not work. with lever still in position to activate signal, push button for hazards. then put signal lever in "off" position. turn off hazards. signals should work. temporarily anyway.
To turn off a fire alarm in your house, locate the alarm and press the reset button or remove the batteries. Make sure to address any potential fire hazards before turning off the alarm.
To safely turn off a gas valve, locate the valve and turn it clockwise until it is fully closed. This will stop the flow of gas and prevent any potential hazards. It is important to only turn off the gas valve if you suspect a gas leak or if instructed to do so by a professional.
No, it is recommended to turn off the CO2 in a kegerator when it is not in use to prevent unnecessary waste and potential safety hazards.
Push in on the black round switch on the column. If you can't do it by hand - try tapping it.
The furnace may not turn off due to a malfunction in the thermostat, a problem with the furnace's control board, or a blocked air filter restricting airflow. It is important to troubleshoot and address the issue promptly to prevent further damage or safety hazards.
To turn off the gas in your house during an emergency, locate the main gas shut-off valve, typically found near the gas meter. Use a wrench to turn the valve clockwise until it is perpendicular to the gas pipe. This will stop the flow of gas into your home and help prevent potential hazards.
replace turn signal flasher, hazard flasher is separate
Turn signals and hazards are two separate curuits. Check/replace your signal light fuse and flasher.
you have a bad turn signal flasher.
If the turn signals are inoperative check the hazard switch, if the hazards don't work replace the hazard switch, the signals will start working. if the hazards are ok ,the turn signal switch may be bad.