We have a tool that sucks all the air from the filler once vacuum is achieved a valve is opened filling the cooling system right from a premixed Prestone bottle. These cars are a pain to fill. Otherwise the tank surges and shoots coolant all over before the thermostat opens. The old days we would use a long transmission funnel and we would jack the right front end off the ground to help the air escape. Snap-On and Mac make a great tool with all adapters.
Yes, a 1999 Ford Taurus Sho Engine will fit in a 2007 Ford Taurus.
On a 1999 Ford Taurus : The engine coolant reservoir is between the engine and the passenger side of the vehicle . It has a thread on cap which is the pressure cap for the engine cooling system
you can remove the engine from the top by leaving transmission still in car
Only the 1999 Ford Taurus SHO has a timing belt. The engine is built by Yamaha and NO it is not an interference engine. Replace the belt at 100,000 miles. All other Ford Taurus's have timing chains.
Yes it will "fit" but the re-wirng problems are very complicated.
On a 1999 Ford Taurus : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
I was looking at the 1999 Ford Taurus Owner Guide and it doesn't show a flex fuel version of the " Vulcan " 3.0 , V6 engine for the 1999 model Ford Taurus
If you are swapping the Vulcan OHV engine, it will work without issue. If you are attempting to swap the Duratec DOHC engine, it will bolt in, but the computer will not be capable of running the engine.
Trouble code P0411 means:Secondary air injection system incorrect flow detected
In the Engine Bay.
The temperature sending unit on the 1999 Ford Taurus v6 is on the rear of the engine. It is closer to the driver side about 7 inches down.
The 1999 Ford Taurus does not have a timing belt. It has a chain that requires no maintenance.