0
I am assuming you mead the frost plugs on the engine block that will push out if the coolant is the block is too weak and the engine is exposed to terrible cold, long enough to freeze the block solid.
Depending which freeze plug it is, (also called a frost plug) you might be lucky enough to not have to remove the engine from the vehicle. Regardless if the plug is completely out or not, it will have to be replaced. It will not seal properly if it has been pushed out at all.
Drill a small hole, e.g. 1/8" in the frost plug. Have a 1/4" lag screw available. Preferably it should be short, ...say 1 to 1&1/2". It will have a hex head. Screw the lag screw into the hole in the frost plug and then pry the old plug out.
It would be advisable at this time to advise you that it may ease the placement of the frost plug if it is very cold. For the regular guy, kitchen freezer might have to do. Some advance shops may have access to liquid gases that are not to be taken lightly for the average do-it your selfers. Also, if the engine block is warm, this will enlarge the opening of the frost plug bore. On a cautionary note, do not heat the frost plug bore with a torch. the differential expansion of the iron could crack the block.
Clean the bore on the frost plug hole, removing any dirt, grease, old sealant, etc. Don't abrade the bore of the hole. Obtain a large brass hammer that will fit into the recess of the new frost plug and another comparable hammer. It would be advisable at this time to place a small film of silicone sealant on the rim of the frost plug and the bore. Place the frost plug against the bore as square as possible. Place the brass hammer head into the recess of the frost plug. Hold the plug in the bore with the brass hammer and strike the brass hammer smartly with the other hammer. This should start the frost plug into the bore. Continue the drive the plug into the bore until the edge fo the plug is just below the edge of the bore. Allow several hours for the sealant so set. Fill the block and radiator with coolant and warm the engine and check for leaks.
BA
Add your answer:
Earn +20 pts
How do you fix a leaky radiator plug 1995 dodge stratus?
Replace the plug.
How do you fix a code 35 for 'engine check' on a 1992 Dodge Spirit?
have the cooling fans checked out.
How do you fix your oil leak 1990 dodge spirit?
use leak stop or something. Where is your oil leak?
How do you fix flat Dodge Dakota?
If the tire has a nail in it,as long as it's not in the side wall but in the middle of the tread, you can can usually pull the nail out and plug it with a plug from the auto parts store.
How do you fix a leaking transmission on 1993 dodge spirit?
It could be leaking from a number of places. Some could be a simple fix and others not so simple. Need more info as to where it is leaking.
How do you fix a freezer fan?
Very carefully?
How to fix multiple cylinder misfire in a 1997 dodge stratus?
A cylinder misfire can be cause by a bad spark plug or a bad fuel injector. Replace the spark plug to see if the problem is corrected.
How do you fix a code 41 in a 1992 dodge spirit 2.5Lt?
The alternator diode(s), stator or rectifier could be faulty or voltage regulator could be malfunctioning.
How do you fix a spark plug?
only way to fix a spark plug is to replace the problem plug with a new one
Cannot remove oil drain plug on your 2000 dodge caravan 3.3v6 the drain plug spins but wont loosen and you need to drain the oil?
Sounds like you need to replace the oil pan to fix the situation.
My 97 Dodge Avenger won't start it sounds like it could be the fuel injectors a blocked fuel line or even a spark plug does anyone know what I can do to try and fix these problems at home?
wire's could be the fix
How do you fix a leaking sink plug?
get a new plug!
