boot
Hen
Go left to right when they are not going right to left
If the shutters are made of wood you can trim them to fit, you can' trim vinyl shutters.
Swap the blade out for a smaller one.. IE.. if the blades are 21" swap the blade that catches to a 20"
from my own experience I found that water was getting into the van from the top of windscreen rubber either on passenger or drivers side...it runs across top of windscreen metalwork behind interior roof trim!....and then trickles onto floor behind side interior trim..also on the van the roof gutters collect water and rust breaks out where black infill trim meets top of windscreen...silly design!!..I have removed roof black trim and cleaned up channel and used good quality black sealant around top[of windscreen..
It is located under the plastic trim panel just in front of the windscreen
E6000
THIS IS A COMMON FAULT ON FIESTA'S THERE IS A HEATER CONTROL VALVE INSIDE THE ENGINE BAY JUST BELOW THE CENTRE OF THE WINDSCREEN WHICH HAS THE COOLANT PIPES CONECTED TO IT. IT IS A CHEAP PART TO REPLACE AND IS EASY TO FIT.
Yes!
If a windscreen is obtained second hand, it may need to be trimmed to fit your car. Then you must remove the plastic mouldings from the edges of the windscreen. Then the windscreen is primed for the caulking and placed in the car. It is best to use gloves during this process.
On the passenger side footwell trim.