If you are talking about the electric low pressure diesel lift pump in the tank, then its a bit of a messy one, but not too hard to do.
Lift up the rear seats, and you will see a round plastic cover in the floor behind the drivers seat. Remove the cover to expose a hole in the floor. Under the hole in the floor you will see the electric pump, it has two pipes going in, and an electrical connectio.
First, remove the electrical connector, and the pipes. The pipes have a push lock to keep them from falling off in use, so you will need to compress the lock to remove them. They are pretty rigid, and there isn't a whole lot of room, so take your time.
around the top of the fuel pump is a locking ring. You need to remove this, and it is going to be pretty stiff. You may want to resort to a hammer and a broad headed screw driver!
Once the ring is loose, you will need to pull the pump up, then twist it and wiggle it free. The hole is NOT directly over the fuel pump, that would make this too easy, its actually offset to right. Make sure you have plenty of rags and wipes as there is going to be a fair amount of diesel that could drip around the interior of your car if you are not careful or prepared. The fuel gauge sender unit is also built into the fuel tank, so keep in mind the metal stalk and float at the bottom of the pump.
Make sure to remove the rubber seal from around the pump carefully as you will not usually get a replacement with the pump. Also, the plastic fuel tank can warp once the pump is removed, and if you leave it a long time, fitting the new pump can be a right Horror!
Take care with the new pump, especially the fuel gauge sender unit, dont bend the arm! Fitting is simply the reverse of removing, take extra care to ensure that the pipes are connected tightly and once fitted that there no leaks from the pipes or the collar.
This took me about 30 minutes to remove and about the same to fit the new one, but that was with numb fingers in -5 centigrade temperatures, your own results may of course vary!
Best of luck!
Remove the belt from your diesel pump. Remove the diesel pump fuel lines. Remove the diesel pump retaining bolts. Reverse the process to install your new diesel pump.
Yes it is.
how do you fit a new water pump on Audi a6
YES they do and all have this fault .you need go to diesel specicalty and skim and new gaskets
The lift pump must have failed, or the pick up tube in the tank has broken.
To change out a water pump in a Series 60 Detroit diesel, you need to locate the water pump in the engine. You need the right tools to remove all the fittings and take the pump out, them replace it with a new one. The owners manual has a list of all engine parts and diagrams.
spposedly the new fuel will not harm older engines.the new fuel has chemical additives to replace the sulphur in old diesel. sulpher is a lubricator in the pump amd injectors
Low sulphur diesel is more than likely to blame, older pumps espically rotary pumps are prone to the new diesel with low sulphur levels, will need to be removed and rekitted, the sulphur is a lubricant in diesel, best to use some ATF bout 200ml with every tank once pump is overhauled
Remove the oil pan, unbolt the pickup tube and pump and replace it with the new pump. You may have to loosen up the engine mounts to jack up the engine for room to work on every thing. I recomend a new pickup tube with the new oil pump.
First post. What you need to do is fill the fuel pump up with diesel and then start it. that avoids these stupid vauxhalls to get airlock. however, now you got to fill the fuel pump with diesel and then tow it and then bump start it. that will allow the vehicle to unair-lock. hope that helps unpickedexpert@blueyonder.co.UK
A torque plate is the cheapest, but having a diesel performance shop adjust the injection pump and install new governor springs is a great mod.
Sometimes you do. If the new fuel pump came with a substitute harness you will need to. The reason is that a change has occurred possibly due to a recall and the old harness won't fit the replacement pump.