answersLogoWhite

0


Best Answer

The factory alarm is part of the engine and body computers, it can not be disconnected.

User Avatar

Wiki User

βˆ™ 10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you disconnect the alarm on a 1998 Chrysler Town and Country?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you disconnect the alarm on a 1998 Chrysler Sebring?

Remove the fuse. There is no fuse for the alarm. It would have to be disconnected from under the hood. see your local Chrysler dealer. The factory alarm is an integral part of the engine and body computers. It can not be disconnected.


Can factory alarm keep transmission from shifting chrysler sebring 1998?

No, the alarm will not affect the trans.


Were is the factory alarm located in a 1998 Chrysler Concorde?

The factory alarm is part of the body and engine computers.


How do you disconnect the alarm system for a 1998 Plymouth Van?

The factory alarm is built into the Body Computer. It is not possible to unhook it.


Where is the cabin air filter on a 1998 Chrysler Town and Country?

A 1998 Chrysler Town and Country does not have a cabin filter.


How do you reset or disconnect car alarm on 1998 Honda Passport?

detach it from the batter ...


How do you replace the alternator on A 1998 town aND country?

Remove the belt from your 1998 Chrysler Town and Country alternator. Disconnect the wiring from the alternator. Loosen and remove the alternator retaining bolts. Reverse the process to put the new alternator on.


How do you reset alarm 1998 Chrysler concord?

Unlock the doors with the key or with the remote.


What does the body computer do on a 1998 Chrysler Town and Country?

The body computer controls the lights, door locks, wipers, part of the theft alarm, keyless entry,


How do you reset the alarm on a 1998 Chrysler Sebring?

To reset the alarm on a 1998 Chrysler Sebring, you will typically need to locate the alarm system's control module. This module is often found under the driver's side dashboard or near the fuse box. Once you locate the control module, you may need to disconnect the battery for a few minutes to reset the alarm system. Reconnect the battery, and the alarm should be reset. If this does not work, consult the vehicle's manual or a professional mechanic for further assistance.


Where is the alarm fuse for a 1998 Chrysler Concorde?

The alarm is part of the engine, body, and sentry key modules. There is no individual fuse.


Where is the alarm system fuse on a 1998 Chrysler Sebring?

The alarm is controlled by the engine and body computers, there isn't an individual fuse.