how do you change the knock sensor in a 2003 Chevy silverado 5.3
The vehicle speed sensor, on your 1994 Chevrolet Silverado pickup truck, is located on the back of the transmission. The speed sensor is labeled as such.
The speed sensor on a Chevy Silverado is located on the tailshaft of the transmission. To remove it, unplug the wire hardness, unscrew the bolt holding it in place, and pull it out.
were is the cam shaft sensor
The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.
NO it does not.
It will be screewed into the transfur case tail shaft housing. Where the drive shaft slides into it.
On driver side of block by the bolt in exhaust manifold closest to front of vehicle
The process to change the pressure sensor is the same for any engine in the 2005 Silverado, but the location may change between engine types. The sensor should be close to the oil filter. Remove the sensor wire, then screw the sensor out. Screw a new sensor in, then reconnect the wire.
how to repace the distributor on an 98 chevy silverado
There are several O2 sensors on that vehicle and they are all threaded into the exhaust system at various points.
unscrew it