take it to a mechanic and say, "can you replace the transmission mount on my '94 Ford Escort"
yellow
A transmission mount, as its name implies, is a place for the transmission to mount to the vehicle. It is also used to dampen vibrations from the transmission.
Begin by loosening your 1991 Chevy Camaro transmission mount bolt. Jack the transmission up a few inches. Remove the transmission mount bolt and the transmission mount bushing. Put the new transmission mount bushing in and reverse the process.
Loosen the transmission mount retaining bolts. Loosen the back to engine retaining bolts. Jack the transmission of approximately 1 inch. Remove the transmission mount bolts. Remove the transmission mount. Reverse the process to install the new transmission mount.
a vibrating transmission could be caused by a bad transmission mount. If the mount breaks then the transmission will physically move causing it to vibrate.
It's a transmission mount.
It's located on the bottom of the transmission behind the front transmission mount. Replacement is moderately difficult. It requires disconnecting the transmission from the sub-frame, lifting the transmission a little, then removing the front mount. It's best done with the van on a hoist.
lift it up. replace. place it down. It's quite simple
The 1997 Chrysler Sebring transmission is equipped with two transmission mounts. There will be a transmission mount at the back of the transmission, on each side.
It supports and holds the transmission in the vehicle from the underside of the transmission.
You might have a broken or worn transmission/engine mount.