I changed my own tranny fluid and filter and gasket last fall. You merely need to get the replacement filter and gasket. Your 99 Intrigue probably has a tranny gasket that can be cleaned and used one more time. My parts guy told me so, and the filter kit explained what to look for as well. Put the car up on jacks or ramps. loosen the tranny filter case bolts. Put your fluid receptical under the case cover. Loosen enough bolts to get the fluid running out. Let it all drain. Remove cover and gasket. Remove the old filter by pulling straight down. Try to get the small O ring gasket from the filter out. I couldn't get mine to come out. Clean up all of the surfaces. Place the new filter into the O ring gasket. Push up into place. I can't remember what gasket liner if any was needed. I think they recommend that you use a soluble grease to merely hold the gasket in place while putting the case cover back on. PUt cover back on with bolts. Use a torque wrench to specs on replacement instructions. Fill er back up. My 99 used about 8 qts to get back to level. Not a hard job.
there is none. the speed sensor is in the tranny
Change what?Change what?
You add tranny fluid right into where the dipstick is
why
The 1999 Olds Intrigue does have a dipstick. Use a funnel to add fluid as needed into the dipstick tube.
take it to a mechanic!!
If you push the fluid button and the wipers move then it is the pump
Answer confusedhow to change a timing chain in 1999 Oldsmobile intrigue
Took me about an hour to change mine, but it was the first time.
On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.
Begin by removing the washer fluid tank hoses from your 1998 Oldsmobile And tree. Remove the washer fluid tank retaining bolts. The washer fluid tank will come off.
Remove the wheel, the calipers and the rotors, reverse procedure with new rotors.